Tax, costs and finance

Cutting energy use in a commercial kitchen

Cut energy use in a restaurant or pub kitchen: measure kWh per cover, set a switch-on schedule, fix refrigeration and extraction, and judge upgrades.

Ava research teamPublished 7 min read

On this page
  1. Why this is worth a manager's time
  2. Measure before you change anything
  3. Write a switch-on schedule
  4. Refrigeration: the 24-hour load
  5. Extraction and ventilation
  6. Hot water, dishwashing and lighting
  7. Getting the team to stick with it
  8. Judging an upgrade
  9. A 30-day energy plan
  10. Frequently asked questions
  11. References

Key takeaways

  • Nine in ten UK accommodation and food businesses were concerned about energy prices in September 2026, more than any other industry.
  • Start with half-hourly meter data and a kWh-per-cover figure, so you can see whether changes work.
  • The cheapest savings come from a written switch-on and switch-off schedule, clean condensers and door seals, and extraction that runs only as hard as cooking needs.
  • Judge equipment upgrades on payback in months against your remaining lease, not on the brochure figures.

Why this is worth a manager's time

Energy has become one of the largest controllable costs in a kitchen. In late October 2026, 56.2% of UK accommodation and food businesses were very concerned about energy prices and a further 34.2% somewhat concerned[1]. A month earlier, 91% were concerned, the highest share of any industry[2]. In a February 2026 trade survey, 93% of hospitality businesses said energy costs were hurting profitability[3].

Concern about energy prices, UK accommodation and food businesses, late October 2026
Concern about energy prices, UK accommodation and food businesses, late October 2026Stacked bar chart. Very concerned: 56.2%; Somewhat concerned: 34.2%; Other answers: 9.6%.Very concerned: 56.2% (56%)Somewhat concerned: 34.2% (34%)Other answers: 9.6% (10%)Concern about energy prices, UK accommodation and food businesses, late October 2026Stacked bar chart. Very concerned: 56.2%; Somewhat concerned: 34.2%; Other answers: 9.6%.Very concerned: 56.2% (56%)Somewhat concerned: 34.2% (34%)Other answers: 9.6% (10%)
  • Very concerned 56.2%
  • Somewhat concerned 34.2%
  • Other answers 9.6%

Source: Office for National Statistics, 2026[1]

Show the data
ItemValue
Very concerned56.2%
Somewhat concerned34.2%
Other answers9.6%

You cannot control the unit price once a contract is signed, but you can control how many units the kitchen uses. Most of the savings below need no capital spending, only a routine that the whole team follows. That is the hard part, and it is why the steps start with measurement: a team that can see the numbers move is far more likely to keep the habits.

Measure before you change anything

If you have a smart or half-hourly meter, ask your supplier or meter operator for the data, or use the online portal many suppliers provide. Plot one normal week. You are looking for three things: the baseline when the venue is closed overnight, the morning ramp when equipment is switched on, and the evening peak during service.

  • A high overnight baseline usually means refrigeration working too hard, equipment left on standby, or extraction, lighting or water heating running when nobody is there.
  • A steep, early morning ramp usually means everything is switched on at once at the start of prep, long before it is needed.
  • A flat line through the afternoon when the kitchen is quiet usually means ovens, fryers and hot cupboards are kept at temperature between services.

Then work out a simple ratio: kilowatt hours per cover. Example: a kitchen that uses 380 kWh on a day it serves 140 covers runs at about 2.7 kWh per cover. The figure itself matters less than the trend. Track it weekly, and compare like with like, a Tuesday with a Tuesday, because a full Saturday will always look more efficient per cover than a quiet Monday.

Write a switch-on schedule

The single most effective habit is a written schedule that says when each piece of equipment is switched on and off. Most kitchen equipment reaches working temperature far faster than staff assume, and the habit of switching everything on as soon as the first person arrives can add hours of unnecessary running every day.

Example switch-on schedule for a mid-sized restaurant kitchen. Adjust the timings to your own equipment and menu.
EquipmentSwitch onSwitch off or turn downWho checks
Combination ovenWhen the first item needs it, not at arrivalBetween services if idle for more than an hourHead chef
FryersShortly before service; one fryer only on quiet sessionsLids on and off between rushesSection chef
Chargrill and griddleShortly before serviceOff as soon as the last order is firedSection chef
Hot cupboards and bain-mariesShortly before pass opensOff at last ordersSous chef
ExtractionWith the first cooking applianceDown to low speed between rushes; off with the last applianceClosing chef
Glasswasher and dishwasherWhen there is a full first loadOff at close; drain and cleanKitchen porter

Laminate the schedule and put it by the main switchboard. Give each item an owner. In the first fortnight, the head chef should check it at the start and end of each shift, and the energy data will show whether it is being followed.

Refrigeration: the 24-hour load

Fridges and freezers run all day and all night, so small inefficiencies add up. Clean condenser coils regularly, because dust and grease make the compressor work harder. Check door seals with the paper test: close the door on a sheet of paper and pull; if it slides out easily, the seal needs replacing. Do not overfill units so that air cannot circulate, and do not put hot food straight in. Keep cold rooms and walk-ins closed, with strip curtains in good condition. Defrost freezers on schedule, because ice build-up insulates the evaporator and wastes energy.

Look at where units are placed too. A fridge next to a range or in a hot corridor with no ventilation will always struggle. Moving one unit a metre, or improving airflow behind it, can make a noticeable difference to how hard it runs. Ask your refrigeration engineer to check refrigerant levels and settings at each service visit and to tell you which units are working hardest.

Extraction and ventilation

Kitchen extraction fans are often run at full speed from opening to close, regardless of how much cooking is happening. Fans that can be turned down when the kitchen is quiet, either manually or through a variable speed drive, use much less electricity at lower speeds and also pull less heated or cooled air out of the dining room. If your system has only one speed, ask a ventilation engineer whether a speed controller can be fitted safely, because extraction must still meet safety and hygiene requirements during cooking.

Keep filters and canopies clean. A grease-clogged filter forces the fan to work harder and is a fire risk. Clean filters on the schedule your ductwork specialist recommends, and keep the records for your insurer.

Hot water, dishwashing and lighting

  • Run dishwashers and glasswashers only with full racks, and check the rinse temperature is set as the manufacturer recommends, not higher.
  • Fix dripping hot taps and pre-rinse sprays immediately. Low-flow pre-rinse spray heads use less hot water for the same job.
  • Keep hot water storage hot enough to control legionella in line with health and safety guidance, but insulate pipes and cylinders so less heat is lost.
  • Fit motion sensors in stores, cellars, toilets and corridors, and switch kitchen lighting to LED as fittings fail.
  • Turn off dining room heating or air conditioning before close, not after the last guest leaves.

Getting the team to stick with it

Energy habits fade within weeks unless someone keeps them visible. Make energy part of the pre-shift briefing for the first month, then once a week. A short script works better than a lecture. Example briefing: "Last week we used 6% less electricity than the week before on the same covers. The fryers went on 40 minutes later and nobody noticed the difference. Tonight, second fryer stays off until we pass 30 covers, and the closing chef turns the canopy down at last orders." Share the weekly kWh per cover figure on the kitchen noticeboard next to the food safety records. Thank the section that improved most. Small, specific instructions tied to a result the team can see do more than any poster about saving the planet, and they keep working after the novelty has gone.

Judging an upgrade

Equipment suppliers will offer induction hobs, new combination ovens, heat-recovery systems and high-efficiency refrigeration. Some are excellent investments; others never pay back in a leased kitchen with a few years left to run. Apply three tests. First, payback: the cost of the item divided by the realistic monthly saving, using your own energy price and running hours. Second, lease length: if payback is longer than your remaining term, the landlord gets the benefit. Third, operational fit: a new oven that speeds up service may be worth more than its energy saving alone.

Example: a replacement fridge costing £2,400 that saves 8 kWh a day at 25p per kWh saves about £2 a day, or about £730 a year, so it pays back in a little over three years. If the old unit is also failing and costing call-out fees, the case is stronger. If you have two years left on the lease and no renewal planned, it is weaker.

Energy prices were among the main reasons UK accommodation and food businesses were considering raising prices in November 2026, cited by 52.8%[4], and 77% of sector SME employers named energy prices as an obstacle in 2025[5]. Every unit you do not use protects margin without asking guests to pay more.

A 30-day energy plan

  1. Days 1 to 7: baseline

    Get half-hourly data, plot a normal week, and calculate kWh per cover for each day.

  2. Days 8 to 14: schedule

    Write and post the switch-on schedule, assign owners, and brief the team at the start of each shift.

  3. Days 15 to 21: maintenance

    Clean condensers and filters, test door seals, fix leaks and book a refrigeration check.

  4. Days 22 to 30: review

    Compare the new week with the baseline, share the result with the team, and pick one upgrade to cost properly.

Once usage is under control, check what you pay per unit with business energy contracts: what to check. The other large fixed costs are covered in employer National Insurance: managing the higher bill, challenging your rateable value: check, challenge, appeal and restaurant rent: reviews, turnover rents and negotiation.

Frequently asked questions

What is a good kWh per cover figure for a restaurant?

There is no single benchmark because menus, equipment and opening hours differ widely. Use your own figure as the baseline and track it weekly against the same day of the week.

Is it cheaper to leave ovens on between services?

Usually not if the gap is more than about an hour. Most modern ovens reach temperature quickly, so turning down or off between services saves energy. Check your manufacturer's guidance.

Will a variable speed extraction fan save money?

Often, because fans use much less power at lower speeds and remove less heated air from the building. It must still provide enough extraction during cooking, so have an engineer specify it.

Should I replace old kitchen equipment to save energy?

Only if the payback period is shorter than the time you expect to stay in the premises, or the equipment is failing anyway. Calculate payback from your own prices and running hours.

References

  1. Office for National Statistics (2026). Business insights and impact on the UK economy, wave 167 dataset (opens in a new tab) ↑

  2. Office for National Statistics (2026). Business insights and impact on the UK economy: 8 October 2026 (opens in a new tab) ↑

  3. UKHospitality, BBPA, BII and Hospitality Ulster (2026). April cost increases will force two-thirds of hospitality to cut more jobs (opens in a new tab) ↑

  4. Office for National Statistics (2026). Business insights and impact on the UK economy, wave 166 dataset (opens in a new tab) ↑

  5. Department for Business and Trade (2025). Longitudinal Small Business Survey 2025: SME employers (businesses with 1 to 249 employees) (opens in a new tab) ↑

Book a demo

See Ava handle your calls.

Book a short demo. We’ll walk through your calls and workflow, and agree what Ava should take care of.

Book a demo